March Status Photos

I have spent a good amount of time getting my panel console fitted. Everything for the most part goes right in, but there are minor cosmetic tweaks and fitting that does need to happen. It is good to see the panel looking like a panel!


As of now, I have the VPX, GTR-20, GSU primary and backup, GEA24 and the AUX fuse block mounted.


Looking back I have a mess!


The engine is coming together nicely. I got my exhaust from Vetterman and they did a wonderful job.


I have the doors complete, but I am waiting on the weather to warm up a bit before I finish cutting my plexi-glass.


Side view






I did notice that the desiccant on a couple of cylinders was starting to go clear. I replaced all of the desiccant in the plug adapters just to get ahead of that.



I have Beringer nosewheel and mains. I am waiting on the weather to warm to finishing dura-coating some of the wheel components.




I have spent a lot of time going through this door. My neighbor caught me the other day in the tail of the plane and I told them that I would be out in a minute because I was a little stuck at that point in time. They responded with "Looks like you should have built it a little bigger." If only it was that easy.