FM-300R on a L1B5 sump

This is a post that is completely out of order as I forgot to publish it when I was working through this fit up. I have a Lycoming Thunderbolt IO-540 with a cold air sump off of a L1B5. when trying to put the FM-300R onto this sump I ran into a bit of a snag. i.e. the sump is in my way!

As you can see here I have about an inch and a half up or out that I need to get in order to get things to line up. I think the BPE cold air sump has a very angled forward face to it that allows this fit up to work.



No real big deal here. This is a standard problem which many places sell spacers for just this problem. In my case I called Don at airflow and ordered a 4 degree spacer. I figured this would do the trick. So close!!! I am about 1/8" from fitting.If you look at the top corner of the spacer you will see it pulled away from the sump because of the top of the servo contacting the sump.



I have the servo on upside down here just to take a photo. This brass hex (the adjustable jet) is what is contacting the sump. I did contemplate just taking the 1/8" off of this hex. Also, Don had mentioned that we could remove the adjustability out of this...


I went back and forth with Don though, and Jeff Schans shipped him out a sump to work on some fit ups. Don agreed to help prototype a new bracket that would push the servo out the 1/8" while also giving me a place to mount up the linkage cables.

Presumably the straight spacer could be pulled back closer to the sump, but I am not sure that buys you any cowl clearance because the straight spacer will be pushing the servo inlet closer to the cowling.

Mounting the Engine!

With my parents in town and my dad ready to spend some time in the garage, it was finally time to hang the engine. The long story short, this was a lot easier than the stories I heard with the motor mount not lining up to the mounting ears. With the engine load leveler on the hoist, this is actually a one person job (its not like you are trying to get the engine bell housing bolts in place while laying under a car!)

I would say the thing that took the most amount of time was getting the lower mounting ear bolts torqued. Not that it was impossible, it was a bit annoying and I ended up taking the rear down tubes off of the sump to get at the nuts.

I am happy to say that everything fit first try. That said, I am going to pop the engine off and re-weld my cross bar on the engine mount. I previously lowered the cross bar in order to clear the sump. I will admit, that when I measured everything up, I never fully mounted the engine mount to the engine. I was looking for about 1/2" of clearance, which I did end up getting... And then I torqued the engine mounts and took the weight off of the engine. I ended up with about 3/32" of an inch when all was said and done. While that may be fine, there is no reason not to re-weld this because it is going to take me all of an hour to take the engine off and put it back on. Plus, since I have procrastinating some building I have been doing a lot of 4130 TIG welding to keep my skills up. 1/16" 2% ceriated tungsten with some 1/16" ER70S-2 does a much better job than my previous 3/32 setup.

Engine Arrival

I owe so many posts that still need to be edited, but this one is quick and easy. The Engine is here! I ended up going with a Thunderbolt. They were a dream to work with. I will post more as I get it opened and mounted.